top of page

LYNX SHREDDER 3700-4100

  Hello! 

  Thanks again for your purchase of the Lynx Shredder Rear Bumper.

PLEASE SEND ALL PHOTOS TO MEDIA@BACKWOODSBMP.COM

 

 Hardware included in kit.

-38 Black rivets (3700 3900) 4100 -42 BLACK RIVETS

-2 short SS rivets (TOP RIVET HOLE FOR GRAB BAR)

-2 Long SS rivets (BOTTOM RIVET HOLE FOR GRAB BAR)

-8 1/4" BOLTS AND NUTS. 

 -START INSTALL BY REMOVING RED REFLECTORS.

-INSTALL LEFT AND RIGHT SIDE PLATES WITH (2) 1/4" BOLTS PER SIDE IN REFLECTOR HOLES ( LEAVE LOOSE )

 -INSTALL GRAB BAR LINING UP 1/4" HOLES.

 

-INSERT 1/4" BOLTS 2 PER SIDE ( LEAVE LOOSE )

   

 -ALIGN GRAB BAR RIVET HOLES

 

-INSERT SHORT SS RIVETS INTO TOP GRAB BAR RIVET HOLE (THIS RIVET DOES NOT GO INTO THE TUNNEL ).

 

-DRILL LOWER RIVET HOLE FOR GRAB BAR USING A 3/16" DRILL BIT

 

-INSERT LONG SS RIVET IN LOWER HOLE.

 -ENSURE THAT BOTH LEFT AND RIGHT SIDE PLATES ARE SEATED FLAT BEFORE TIGHTING ALL 1/4" BOLTS.

 

-ONCE ALL BOLTS ARE TIGHT POP ALL 4 GRAB BAR RIVETS. 

 - USING A 3/16 DRILL BIT, DRILL THE REMAINING HOLES OUT. 

-USING BLACK RIVETS BEGIN TO SECURE THE SIDE PLATES TO SNOWMOBILE.

-STARTING AT YOUR TAILIGHT, WORK FORWARD TO COMPLETE THE INSTALL. 

IF YOU HAVE ANY OTHER QUESTIONS PLEASE RE-READ THESE INSTALL INSTRUCTIONS. IF ALL ELSE FAILS PLEASE HAVE ALL OF YOU INFORMATION READY BEFORE YOU CALL OR EMAIL US.

THANK YOU AND WELCOME TO THE TEAM!

 

   

   

bottom of page