Thanks again for your purchase of the Axys Rear bumper!
You should have in your kit:
-BackwoodsBMP rear bumper
-The Backwoods BMP Polaris axys rear bumper is one of the furthest forward reaching bumpers. For this reason we need to be able to overcome the infrastructure that has previously impeded other companies.
-Now that the procedure above has been completed on both sides set the bumper on top of the running boards as if it was about to drop vertically into place.
-Following the picture and instructions below you will now create the ability for you new rear bumper to Fall into place, It may be easier to have 2 people for this operation.
-Now that your bumper has been put into place make sure to replace and retighten all previous bolts. After aligning the two furthest back main mounting holes using your stock mounting locations and bolts, you may now proceed to fully fasten you backwoodsBMP rear bumper to your snowmobile. Use a drill bit to drill through hole locations on bumper and to install provided Rivets. While you are not required to use ALL rivets, it is suggested.
Please make sure to Contact us if you have any questions or concerns.