Hello! 

​

  Thanks again for your purchase of the Gen 4  Rear Bumper.

​

PLEASE SEND ALL PHOTOS TO MEDIA@BACKWOODSBMP.COM

 

 Hardware included in kit.

-30 Black rivets

-2 Long SS rivets (for grab bar one per side)

-4 1/4" BOLTS AND NUTS. (For Grab Bar Mounting)

-10 M6 X 1.00 Nuts (Use with Factory bumper bolts)

​

-START INSTALL BY REMOVING Factory Bumper. (save all bolts)

-INSTALL LEFT AND RIGHT SIDE PLATES WITH (2) Factory BOLTS PER SIDE Using M6 X 1.00 nuts. ( LEAVE LOOSE )

-INSTALL GRAB BAR LINING UP 1/4" HOLES.

 

-INSERT 1/4" BOLTS 2 PER SIDE ( LEAVE LOOSE )

   

-ALIGN GRAB BAR RIVET HOLES (one per side) You will have to drill a 3/16" hole in tunnel for this rivet.

 

-INSERT SS RIVET IN RIVET HOLE FOR GRAB BAR.

​

-ENSURE THAT BOTH LEFT AND RIGHT SIDE PLATES ARE SEATED FLAT BEFORE TIGHTING ALL BOLTS.

 

-ONCE ALL BOLTS ARE TIGHT POP BOTH GRAB BAR RIVETS. 

​

-USING A 3/16 DRILL BIT, DRILL THE REMAINING 3/16" HOLES OUT. ALL 3/16" HOLES GET DRILLED FOR BLACK RIVETS.

​

-USING BLACK RIVETS BEGIN TO SECURE THE SIDE PLATES TO SNOWMOBILE.

​

-STARTING AT YOUR TAILIGHT, WORK FORWARD TO COMPLETE THE INSTALL. 

​

-ALL GEN 4 REARS FIT A VARIETY OF DIFFRENT STYLE TUNNELS IN THAT LENGHT. SOME HOLES MAY NOT APPLY TO YOUR

​

IF YOU HAVE ANY OTHER QUESTIONS PLEASE RE-READ THESE INSTALL INSTRUCTIONS. IF ALL ELSE FAILS PLEASE HAVE ALL OF YOU INFORMATION READY BEFORE YOU CALL OR EMAIL US.

​

THANK YOU AND WELCOME TO THE TEAM!

​

​

​

 

​

​

   

   

​

​

​

​

​

​