Hello! 

​

  Thanks again for your purchase of the Lynx Shredder Rear Bumper.

​

PLEASE SEND ALL PHOTOS TO MEDIA@BACKWOODSBMP.COM

 

 Hardware included in kit.

-38 Black rivets (3700 3900) 4100 -42 BLACK RIVETS

-2 short SS rivets (TOP RIVET HOLE FOR GRAB BAR)

-2 Long SS rivets (BOTTOM RIVET HOLE FOR GRAB BAR)

-8 1/4" BOLTS AND NUTS. 

​

 -START INSTALL BY REMOVING RED REFLECTORS.

-INSTALL LEFT AND RIGHT SIDE PLATES WITH (2) 1/4" BOLTS PER SIDE IN REFLECTOR HOLES ( LEAVE LOOSE )

 -INSTALL GRAB BAR LINING UP 1/4" HOLES.

 

-INSERT 1/4" BOLTS 2 PER SIDE ( LEAVE LOOSE )

   

 -ALIGN GRAB BAR RIVET HOLES

 

-INSERT SHORT SS RIVETS INTO TOP GRAB BAR RIVET HOLE (THIS RIVET DOES NOT GO INTO THE TUNNEL ).

 

-DRILL LOWER RIVET HOLE FOR GRAB BAR USING A 3/16" DRILL BIT

 

-INSERT LONG SS RIVET IN LOWER HOLE.

​

 -ENSURE THAT BOTH LEFT AND RIGHT SIDE PLATES ARE SEATED FLAT BEFORE TIGHTING ALL 1/4" BOLTS.

 

-ONCE ALL BOLTS ARE TIGHT POP ALL 4 GRAB BAR RIVETS. 

​

 - USING A 3/16 DRILL BIT, DRILL THE REMAINING HOLES OUT. 

​

-USING BLACK RIVETS BEGIN TO SECURE THE SIDE PLATES TO SNOWMOBILE.

​

-STARTING AT YOUR TAILIGHT, WORK FORWARD TO COMPLETE THE INSTALL. 

​

IF YOU HAVE ANY OTHER QUESTIONS PLEASE RE-READ THESE INSTALL INSTRUCTIONS. IF ALL ELSE FAILS PLEASE HAVE ALL OF YOU INFORMATION READY BEFORE YOU CALL OR EMAIL US.

​

THANK YOU AND WELCOME TO THE TEAM!

​

​

​

 

​

​

   

   

​

​

​

​

​

​